2008-2009 Hilux TRD · Service Manual Tyre and Wheel

Tyre and Wheel System

Tyre and Wheel

INSPECTION
1. INSPECT TYRE
(a) Inspect tyre size.
Tyre size:
265/65 R17 112S
-
(b) Measure the tyres for wear and correct inflation pressure.
Cold tyre inflation pressure
Load
Up to 140 km/h
Above 140 kmh
Up to 4 occupants
and 200 kg load
220 kPa
(2.2 kgf*cm2, 32 psi)
250 kPa
(2.5 kgf*cm2, 36 psi)
More than 4 occupants and 200 kg load
250 kPa
(2.5 kgf*cm2, 36 psi)
250 kPa
(2.5 kgf*cm2, 36 psi)
-
(c) Using a dial indicator, measure the tyre runout.
Tyre runout:
3.0 mm (0.118 in.) or less
-
2. ROTATE TYRE
(a) Rotate the tyres.
-
3. INSPECT WHEEL BALANCE
(a) Check and adjust the balance of the wheels.
Imbalance after adjustment:
10.0 g (0.35 oz.) or less
-
4. INSPECT FRONT WHEEL BEARING BACKLASH
(a) Remove the front wheel.
-
(b) Remove the front disc brake cylinder assembly ( Click Here )
-
(c) Remove the front disc.
-
(d) Using a dial indicator, check the backlash near the centre of the axle hub.
Maximum backlash:
0.05 mm (0.0020 in.)
If the backlash is greater than the maximum, replace the bearing.
-
5. INSPECT FRONT AXLE HUB DEVIATION
(a) Using a dial indicator, check the deviation at the surface of the axle hub.
Maximum deviation:
0.05 mm (0.0020 in.)
If the deviation is greater than the maximum, replace the bearing.
-
6. CHECK REAR AXLE SHAFT BEARING BACKLASH
(a) Remove the rear wheel.
-
(b) Remove the brake drum.
-
(c) Using a dial indicator, check the backlash near the centre of the axle shaft.
Maximum backlash:
0.05 mm (0.0020 in.)
If the backlash is greater than the maximum, replace the bearing.
-
7. INSPECT REAR AXLE SHAFT DEVIATION
(a) Using a dial indicator, check the deviation at the surface of the axle shaft.
Maximum deviation:
0.1 mm (0.0039 in.)
If the deviation is greater than the maximum, replace the bearing.
-