ECD SYSTEM (w/ EGR Cooler) > MIL Circuit |

| 1.CHECK THAT MIL IS ILLUMINATED |
Perform troubleshooting in accordance with the chart below.
| MIL Condition | Proceed to |
| MIL remains ON | A |
| MIL does not illuminate | B |
|
| ||||
| A | |
| 2.CHECK WHETHER MIL TURNS OFF |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Check whether any DTCs have been stored. Note them down if necessary.
Clear DTCs (Click here).
Check if the MIL turns off.
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the E5 ECM connector.
Turn the ignition switch ON.
Check that MIL is not illuminated.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||
| 4.CHECK THAT MIL IS ILLUMINATED |
Check if the MIL illuminated when the ignition switch is turns ON.
|
| ||||
| NG | |
| 5.CHECK THAT ENGINE STARTS |
Turn the ignition switch ON.
Start the engine.
| Result | Proceed To |
| Engine starts | A |
| Engine does not start* | B |
|
| ||||
| A | |
| 6.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
![]() |
Disconnect the C8 combination meter connector.
Disconnect the E5 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C8-39 - W (E5-12) | Below 1 Ω |
| Tester Connection | Specified Condition |
| C8-39 or W (E5-12) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||