Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



DTC CHECK/CLEAR (When Using Intelligent Tester)
  1. Check for DTCs.

    1. Turn the ignition switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the intelligent tester on.

    5. Read the DTCs following the prompts on the tester screen. Enter the following menus: Chassis / ABS/VSC/TRC / DTC.

    6. Check the details of the DTCs (Click here).

  2. Clear the DTCs.

    1. Turn the ignition switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the intelligent tester on.

    5. Operate the intelligent tester to clear the codes. Enter the following menus: Chassis / ABS/VSC/TRC / DTC / Clear.


DTC CHECK/CLEAR (When not Using Intelligent Tester)


  1. Check for DTCs.



      C166029E04
    1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.

    3. Observe the blinking pattern of the ABS warning and VSC OFF indicator lights in order to identify the DTC.

      HINT:
      If no code appears, inspect the TC and CG terminal circuit, and ABS warning and VSC OFF indicator light circuits.

      Trouble Area
      See procedure
      TC and CG terminal circuit
      Click here
      ABS warning light circuit (Remains on)
      Click here
      ABS warning light circuit (Does not come on)
      Click here
      VSC OFF indicator light circuit (Remains on)
      Click here
      VSC OFF indicator light circuit (Does not come on)
      Click here



    4. As an example, the illustration below shows the blinking patterns of the normal system code and trouble codes 11 and 21 for the ABS warning and VSC OFF indicator lights.


      C169592E01

    5. After completing the check, disconnect terminals TC and CG of the DLC3 to turn off the display.
      If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.



  2. Clear the DTCs.



      C166029E04
    1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.



    3. BR03890
    4. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    5. Check that the ABS warning and VSC OFF indicator lights indicate the normal system code.

    6. Remove SST from the terminals of the DLC3.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch to ON.

  2. Check that the ABS warning and VSC OFF indicator lights go off within approximately 3 seconds after turning the ignition switch to ON.