VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light Remains ON |

| 1.CHECK FOR DTC |
Check if DTCs for the ABS are recorded (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| A | |
| 2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU IG1 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S35-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU GND1 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-1 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |

Turn the ignition switch off.
Disconnect the skid control ECU connector.
Disconnect the combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-10 (WA) - C8-38 | Always | Below 1 Ω |
| S35-10 (WA) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU EXI3 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S35-28 (EXI3) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 7.READ VALUE USING INTELLIGENT TESTER (ABS WARNING LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and the tester on.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| ABS Warning Light | ABS warning light / ON or OFF | ON: ABS warning light ON OFF: ABS warning light OFF | - |
Perform the Active Test of the skid control ECU using the intelligent tester (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| ABS Warning Light | ABS warning light | Warning light ON / OFF | Observe combination meter |
| Result | Proceed to | |
| Data List Display | Data List Display When Performing Active Test ON/OFF Operation | |
| ON | Does not change between ON and OFF | A |
| Changes between ON and OFF | B | |
| OFF | Does not change between ON and OFF | A |
| Changes between ON and OFF | B | |
|
| ||||
| A | ||
| ||