DTC C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone |
DTC C1336/39 Zero Point Calibration of Acceleration Sensor Undone |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1210/36 | Zero point calibration of yaw rate sensor undone. |
|
| C1336/39 | When either condition below is met:
|
|
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR |
Perform the zero point calibration of the yaw rate and acceleration sensor (Click here).
| NEXT | |
| 2.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTC(s) (Click here).
While driving the vehicle at a speed of 40 km/h (25 mph) or more, turn the steering wheel and decelerate the vehicle by depressing the brake pedal.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC output | A |
| DTC not output | B |
|
| ||||
| A | |
| 3.CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor has been installed properly (Click here).
|
| ||||
| OK | ||
| ||