Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Skid Control Buzzer Circuit

for Preparation Click here


DESCRIPTION

The skid control buzzer sounds during VSC operation.

WIRING DIAGRAM


C167364E07


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SKID CONTROL BUZZER)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Turn the intelligent tester on.

  1. Select the Active Test mode on the intelligent tester (Click here).

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer ON / OFF
    Buzzer can be heard

  1. Check that the buzzer sounds/stops when turning the skid control buzzer on/off using the intelligent tester.
    Result 
    Result
    Proceed to
    Buzzer does not sound or sounds constantly
    A
    Buzzer sounds/stops
    B

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



B
USE SIMULATION METHOD TO CHECK
A


2.INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL)


    C190631E04
  1. Turn the ignition switch off.

  1. Disconnect the skid control buzzer connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S36-2 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK


3.INSPECT SKID CONTROL BUZZER ASSEMBLY


    C190630E03
  1. Turn the ignition switch off.

  1. Remove the skid control buzzer (Click here).

  1. Connect the negative (-) battery terminal to terminal 1 (BZ) of the skid control buzzer, and the positive (+) battery terminal to terminal 2 (IG1), and then check that the buzzer sounds.

    OK:
    The skid control buzzer sounds.



NG
REPLACE SKID CONTROL BUZZER ASSEMBLY
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SKID CONTROL BUZZER)

C190632E04

  1. Disconnect the skid control ECU connector.

  1. Disconnect the skid control buzzer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S35-21 (BZ) - S36-1 (BZ)
    Always
    Below 1 Ω
    S35-21 (BZ) - Body ground
    Always
    10 kΩ or higher

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY