Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR (for 4WD and Pre-Runner)

FRONT SPEED SENSOR (for 4WD and Pre-Runner) > INSTALLATION

for Preparation Click here


HINT:
  1. The procedures listed below are for the LH side.
  2. Other than areas where instructions are provided, use the same procedures for the LH side and RH side.



1. INSTALL SKID CONTROL SENSOR CLAMP LH


  1. Install the skid control sensor clamp with the bolt.


    C188013E01

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }

    NOTICE:
    Install the clamp so that the rotation stopper touches the knuckle.



2. INSTALL SKID CONTROL SENSOR CLAMP RH


  1. Install the skid control sensor clamp with the bolt.


    C188014E01

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }

    NOTICE:
    Install the clamp so that the rotation stopper touches the knuckle.



3. INSTALL FRONT SPEED SENSOR LH


  1. Install the speed sensor with the bolt.


    C188002E01

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 ft.*lbf }

    NOTICE:
    1. Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
    2. While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
    3. After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
    4. When installing the sensor, do not twist the wire harness.

  1. Install the harness clamp with the bolt.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    NOTICE:
    1. When installing the clamp, do not twist the wire harness.
    2. Make sure the clamp rotation stopper touches the installation position.

  1. Attach the 2 clamps.



    C189998E01
  1. Attach the clamp.

  1. Install the 2 harness clamps with the 2 bolts.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    NOTICE:
    1. When installing the clamps, do not twist the wire harness.
    2. Make sure the clamp rotation stopper touches the installation position.



    C188017E01
  1. Attach the 2 clamps.

    NOTICE:
    When attaching the clamps, do not twist the wire harness.



  1. Connect the connector.


    C188016E01

    NOTICE:
    1. Do not attach the connector to the radiator fan shroud before connecting the connector.
    2. Securely connect the connector.

  1. Attach the 2 clamps and the connector.

    NOTICE:
    When attaching the clamps, do not twist the wire harness.



4. INSTALL FRONT WHEEL

Torque:
105 N*m{ 1071 kgf*cm , 77 ft.*lbf }



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. CHECK SPEED SENSOR SIGNAL
  1. w/ ABS:
    Check the speed sensor signal (Click here).

  1. w/ VSC:
    Check the speed sensor signal (Click here).