Home › BRAKE › PARKING BRAKE › PARKING BRAKE LEVER

PARKING BRAKE LEVER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE CONSOLE BOX ASSEMBLY
(Click here)


3. REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY


C112489E01
  1. Remove the lock nut and wire adjusting nut labeled A.

  1. Remove the 2 bolts labeled B and lever (with the No. 1 parking brake cable).

  1. Bend the claw labeled C so that the cable can be removed.

  1. Remove the 2 bolts and 2 nuts labeled D.

  1. Disconnect the cable from the lever.

  1. Disconnect the parking brake switch connector.

  1. Remove the screw and switch from the lever.