MANUAL TRANSMISSION ASSEMBLY > INSTALLATION |
| 1. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |
![]() |
Align the input shaft with the clutch disc and install the transmission to the engine.
Install the 4 bolts.
| 2. INSTALL STIFFENER PLATE |
![]() |
Install the stiffener plate RH with the 4 bolts.
Install the stiffener plate LH with the 4 bolts.
| 3. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR |
![]() |
Install the mounting insulator with the 4 bolts.
| 4. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Install the frame crossmember with the 4 bolts and 4 nuts.
Install the 4 set bolts to the rear No. 1 engine mounting insulator.
| 5. INSTALL STARTER ASSEMBLY |
Install the starter (Click here).
| 6. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY |
![]() |
Install the clutch release cylinder with the 2 bolts.
| 7. CONNECT WIRE HARNESS |
Connect the back-up light switch connector and speedometer sensor connector.
| 8. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Install the front exhaust pipe (Click here).
| 9. INSTALL REAR PROPELLER SHAFT ASSEMBLY |
Install the rear propeller shaft (Click here).
| 10. INSTALL NO. 2 FRAME CROSSMEMBER ASSEMBLY |
![]() |
Install the frame crossmember with the 4 bolts and 4 nuts.
| 11. ADD MANUAL TRANSMISSION OIL |
![]() |
| 12. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY |
Cover the shift lever cap with a cloth.
Press down on the shift lever cap and rotate it clockwise to install it.
| 13. INSTALL SHIFT LEVER BOOT ASSEMBLY |
![]() |
Install the shift lever boot with the 4 screws and 2 clips.
w/o Console Box:
Install the floor carpet, front seat, front door scuff plate, etc.
| 14. INSTALL CONSOLE BOX ASSEMBLY |
![]() |
Install the console box with the 2 clips, 4 screws <F> and 2 bolts <E>.
| 15. INSTALL UPPER CONSOLE PANEL ASSEMBLY |
![]() |
Attach the 12 claws to install the console panel.
| 16. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
w/ M/T:
Twist the knob in the direction indicated by the arrow to install it.
w/ 4WD:
Twist the transfer shift lever knob in the direction indicated by the arrow to install it.
| 17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 18. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 19. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).