Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Power Seat)

FRONT SEAT OUTER BELT ASSEMBLY (for Power Seat) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat assembly LH (Click here)



3. REMOVE FRONT SEAT ASSEMBLY RH
  1. Remove the front seat assembly RH (Click here).



4. REMOVE FRONT DOOR SCUFF PLATE LH


B085562E01
  1. Using a screwdriver, detach the 7 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 3 clips and remove the scuff plate.



5. REMOVE FRONT DOOR OPENING TRIM LH


6. REMOVE REAR DOOR SCUFF PLATE LH


B085564E01
  1. Using a screwdriver, detach the 7 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the scuff plate.



7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


8. REMOVE CENTER PILLAR GARNISH LOWER LH


    B113106
  1. Remove the front seat outer belt anchor's built-in bolt and disconnect the belt's anchor.



    B085563E01
  1. Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.



9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


    B086294E07
  1. Remove the outer belt shoulder anchor.

    1. Using a screwdriver, detach the 4 claws and remove the seat belt anchor cover cap.

      HINT:
      Tape the screwdriver tip before use.

    2. Remove the bolt and shoulder anchor.



    B084921E01
  1. Remove the bolt and seat belt.



    B113099
  1. w/ Pretensioner:

    1. Disconnect the pretensioner connector as shown in the illustration.



    2. B120576
    3. Remove the bolt and seat belt.



10. REMOVE CENTER PILLAR GARNISH LH


    B086294E03
  1. Disconnect the front seat outer belt's shoulder anchor.

    1. Using a screwdriver, detach the 4 claws and remove the seat belt anchor cover cap.

      HINT:
      Tape the screwdriver tip before use.

    2. Remove the bolt and disconnect the shoulder anchor.



    B085561E01
  1. Using a clip remover, detach the clip.

  1. Pull the garnish in the direction indicated by the arrow in the illustration to detach the claw. Then remove the garnish.



11. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


B084923E03
  1. Remove the bolt.

  1. Rotate the adjuster approximately 90° , and then pull and remove it.



12. REMOVE SHOULDER BELT ANCHORAGE PLATE COVER


B087816E07
  1. Remove the plate cover.