Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Power Seat)

FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for RHD and LHD vehicles.
  2. The procedures listed below are for LHD vehicles.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



2. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat assembly (Click here).



3. REMOVE FRONT SEAT ASSEMBLY RH
  1. Remove the front seat assembly (Click here).



4. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


B087811E01
  1. Detach the clamp.



    B089297E01
  1. Detach the wire harness from the clamp.

  1. Remove the nut and seat belt.

  1. Remove the buckle cover.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)


    B113100E01
  1. w/ Passenger Seat Belt Warning Light:

    1. Detach the 2 clamps and disconnect the connector.



    2. B087812E02
    3. Detach the wire harness from the clamp.

  1. Remove the nut and seat belt.

  1. Remove the buckle cover.