DTC P0488 Exhaust Gas Recirculation Throttle Position Control Range / Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0488 |
|
|
| Condition | Throttle Valve Position |
| Moment when accelerator pedal is further depressed or released at 3,000 rpm | Opening angle varies smoothly |


| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0488) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0488 | A |
| P0488, P0122 and/or P0123 | B |
|
| ||||
| A | |
| 2.CHECK IF DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC / Clear.
Clear the DTCs.
Start the engine and accelerate the engine from idle to 3,000 rpm 3 times quickly.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Display (DTC output) | Proceed to |
| P0488 | A |
| No output | B |
| Condition | Throttle Valve Position |
| Moment when accelerator pedal is further depressed or released at 3,000 rpm | Opening angle varies smoothly |
|
| ||||
| A | |
| 3.INSPECT THROTTLE CONTROL MOTOR |
![]() |
Disconnect the T1 throttle control motor.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| +B (T1-2) - Body ground | 11 to 14 V |
| Tester Connection | Specified Condition |
| GND (T1-3) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (THROTTLE CONTROL MOTOR - ECM) |
![]() |
Disconnect the T1 throttle control motor connector.
Disconnect the E7 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| LUSL (T1-1) - LUSL (E7-4) | Below 1 Ω |
| Tester Connection | Specified Condition |
| LUSL (T1-1) or LUSL (E7-4) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.REPLACE DIESEL THROTTLE BODY ASSEMBLY |
Replace diesel throttle body assembly (Click here).
| NEXT | |
| 6.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester ON.
Enter the following menu: Powertrain / Engine / DTC / Clear.
Clear DTCs.
Start the engine and warm it up.
Accelerate the engine from idle to 3,000 rpm 3 times quickly.
Select the following menu items: Powertrain / Engine / DTC.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0488 | A |
| No output | B |
|
| ||||
| A | ||
| ||