DTC P1238 Injector Malfunction |

| DTC No. | DTC Detection Condition | Main Trouble Area | Related Trouble Area |
| P1238 | Engine speed fluctuation is large when idling (2 trip detection logic) |
|
|
| Engine Speed | Fuel Pressure (MPa) |
| Idling | Approximately 30 to 40 |
| 3,000 rpm (No engine load) | Approximately 45 to 75 |
| Required Sensors | Crankshaft position sensor |
| Frequency of operation | Continuous |
| Duration | 10 minutes |
| MIL Operation | 2 driving cycles |
| Item | Specification | |
| Minimum | Maximum | |
| Engine | At idling | |
| Engine speed | 750 rpm | - |
| Engine coolant temperature | 20°C (68°F) | - |
| Threshold |
| The number of irregular changes in the crankshaft rotation speed. |
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P1238) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Read DTCs.
| Display (DTC output) | Proceed to |
| P1238 | A |
| P1238 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (ENGINE WIRE HARNESS) |
Check the wire harness and connector connections.
|
| ||||
| OK | |
| 3.READ VALUE USING INTELLIGENT TESTER (COMPENSATION OF INJECTION VOLUME BETWEEN CYLINDERS) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Injection Feedback Val #1, #2, #3 and #4.
Read the value.
Any cylinders that have a higher compensatory injection volume than shown above are considered to be faulty. Use the following steps to inspect and repair the cylinders.
| Result | Proceed to |
| Faulty cylinder is not identified | A |
| Faulty cylinder is identified | B |
|
| ||||
| A | |
| 4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (INJECTION CUT FOR IDENTIFYING MALFUNCTION CYLINDER) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester ON.
Enter the following menus: Powertrain / Engine / Active Test / Control the Cylinder #1 to #4 Fuel Cut.
Check the four cylinders in sequence to identify a faulty cylinder by performing the power-balance inspection.
| NEXT | |
| 5.CHECK CYLINDER COMPRESSION PRESSURE OF MALFUNCTIONING CYLINDER |
Check the cylinder compression pressure.
|
| ||||
| OK | |
| 6.CHECK VALVE CLEARANCE OF MALFUNCTIONING CYLINDER |
|
| ||||
| NG | |
| 7.CHECK IF DTC OUTPUT RECURS (DTC P1238) |
|
| ||||
| NG | |
| 8.REPLACE INJECTOR ASSEMBLY |
Replace injector assembly (Click here).
| NEXT | |
| 9.CHECK IF DTC OUTPUT RECURS (DTC P1238) |
| NEXT | ||
| ||