BRAKE MASTER CYLINDER (w/ VSC) > INSTALLATION |
| 1. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY |
![]() |
Apply a light coat of lithium soap base glycol grease to 2 new grommets and install them to the master cylinder.
Install the reservoir with the master cylinder pin.
| 2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY |
Install a new O-ring to the master cylinder.
![]() |
Install the master cylinder and brake tube way to the booster with the 2 nuts.
Using a union nut wrench, connect the 4 brake lines to the brake master cylinder and brake tube way.

Connect the brake fluid level warning switch connector to the master cylinder.
for Manual Transmission:
Connect the clutch reservoir tube to the master cylinder reservoir.
| 3. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
| 4. BLEED AIR FROM BRAKE MASTER CYLINDER |
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.
Slowly depress and hold the brake pedal.
![]() |
Cover the outer holes with your fingers, and release the pedal.
Repeat the 2 previous steps 3 or 4 times.
Using a union nut wrench, connect the 2 brake lines to the master cylinder.
| 5. BLEED AIR FROM BRAKE LINE |
Remove the bleeder plug cap.
Connect a vinyl tube to the bleeder plugs.
Depress the pedal several times, and then loosen the bleeder plug with the pedal depressed.
When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.
Repeat the 2 previous steps until all the air in the brake fluid is gone.
Tighten the bleeder plug.
Install the cap.
![]() |
Bleed air from the brake line for each wheel by repeating the above procedures.
| 6. BLEED AIR FROM CLUTCH LINE (for Manual Transmission) |
![]() |
Remove the bleeder plug cap.
Connect the vinyl tube to the bleeder plug.
Depress the clutch pedal several times, and then loosen the bleeder plug with the pedal depressed.
At the point when fluid stops coming out, tighten the bleeder plug, and then release the clutch pedal.
Repeat the previous 2 steps until all the air in the fluid is completely bled out.
Tighten the bleeder plug.
Install the bleeder plug cap.
Check that all the air has been bled out of the clutch line.
| 7. CHECK BRAKE FLUID LEVEL IN RESERVOIR |
![]() |
Check the fluid level and add fluid if necessary.
| 8. CHECK FOR BRAKE FLUID LEAKAGE |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. CHECK SRS WARNING LIGHT |
w/ Airbag System:
Check the SRS warning light (Click here).