DTC 41 Air Mix Damper Control Servo Motor Circuit (Passenger Side) |
| DTC Code | Detection Item | Trouble Area |
| 41 | Air mix damper control servo motor activation request signal is output, but servo motor position data does not change or is inaccurate |
|

| 1.PERFORM ACTUATOR CHECK |
Warm up the engine.
Enter actuator check mode (Click here).
Press the DEF switch to change to the step operation (Click here).
Press the DEF switch to check the air flow by hand.
| Display Code | Air Mix Damper Position |
| 0 | COOL side (0% open) |
| 1 | COOL side (0% open) |
| 2 | COOL side (0% open) |
| 3 | COOL side (0% open) |
| 4 | COOL/HOT (50% open) |
| 5 | COOL/HOT (50% open) |
| 6 | HOT side (100% open) |
| 7 | HOT side (100% open) |
| 8 | HOT side (100% open) |
| 9 | HOT side (100% open) |
| Result | Proceed to |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | A |
| OK (Checking from the DTC) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (AIR MIX DAMPER SERVO - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the D17 servo connector.
Disconnect the A37 and A38 amplifier connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D17-5 (MHD) - A37-17 (AMH) | Always | Below 1 Ω |
| D17-4 (MCD) - A37-19 (AMC) | ||
| D17-3 (MHP) - A38-23 (PMB) | ||
| D17-2 (MCP) - A38-24 (PMA) | ||
| D17-1 (SG) - A38-20 (SG-1) | ||
| D17-1 (SG) - Body ground | Always | 10 kΩ or higher |
| D17-2 (MCP) - Body ground | ||
| D17-3 (MHP) - Body ground | ||
| D17-4 (MCD) - Body ground | ||
| D17-5 (MHD) - Body ground |
|
| ||||
| OK | |
| 3.CHECK AIR MIX DAMPER SERVO SUB-ASSEMBLY (AIR MIX DAMPER SERVO MOTOR) |
Check if the malfunction disappears when a normally functioning air mix damper servo (air mix damper servo motor) is installed.
|
| ||||
| OK | ||
| ||