Home › BODY › SEAT › FRONT POWER SEAT MOTOR ASSEMBLY (for Slide)

FRONT POWER SEAT MOTOR ASSEMBLY (for Slide) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
If the rear power seat motor has been dropped, replace it with a new one.



1. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).



2. REMOVE RECLINING POWER SEAT SWITCH KNOB


    B207076E01
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


    B207077E01
  1. Using a screwdriver, detach the 4 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT CUSHION SHIELD RH


    B207078
  1. Remove the 2 screws.



    B207039
  1. Remove the 3 screws.

  1. Detach the claw and guide.

  1. Remove the cushion shield.



5. REMOVE FRONT POWER SEAT SWITCH


    B207080
  1. Remove the 3 screws.

  1. Disconnect the connector and remove the switch.



6. REMOVE FRONT SEAT CUSHION INNER SHIELD RH


    B207199
  1. Remove the screw.

  1. Pull the cushion inner shield to detach the claw and guide.



    B207617
  1. Pull the cushion inner shield to detach the claw and remove the cushion inner shield.



7. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH


B087811E01
  1. Detach the clamp.



    B089297E01
  1. Detach the wire harness from the clamp.

  1. Remove the nut and seat belt.

  1. Remove the buckle cover.



8. REMOVE SEAT CUSHION COVER WITH PAD


    B207501
  1. Remove the hog rings.



  1. Detach the hooks and remove the seat cushion cover with pad.


    B207081



9. REMOVE FRONT POWER SEAT MOTOR ASSEMBLY (for Slide)


    B207048
  1. Detach the 2 wire harness clamps.

  1. Detach the 4 clamps indicated by the arrows in the illustration and remove the seat cushion spring.



    B206614
  1. Remove the 4 bolts and seat cushion frame.



    B206610
  1. Put matchmarks on the seat track rail and sliding unit of the seat frame.

  1. Disconnect the connector.



    B108592
  1. Connect the positive (+) battery terminal to terminal 1 of the power seat motor and the negative (-) battery terminal to terminal 2 and slide the seat to the foremost position.



    B207101
  1. Detach the claw and disconnect the connector from the seat frame.

  1. Loosen the 2 nuts.



    B108592
  1. Connect the positive (+) battery terminal to terminal 2 of the power seat motor and the negative (-) battery terminal to terminal 1 and slide the seat to the rearmost position.



    B206612
  1. Using a 5 mm socket hexagon wrench, remove the 2 bolts.

  1. Using a 4 mm socket hexagon wrench, remove the 4 bolts.

  1. Remove the 2 nuts and front power seat motor assembly with slide cable.

    NOTICE:
    Do not apply excessive force to the slide cable (do not bend the side cable 60° or more).



    B207102
  1. Remove the slide cable.