Home › ENGINE ยท 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > PRECAUTION

for Preparation Click here



1.INITIALIZATION

NOTICE:
When the negative (-) battery cable is disconnected, initialize the following systems after the cable is reconnected.


System Name
See Procedure
Meter / Gauge System
Click here

HINT:
Initialization cannot be completed by only disconnecting the battery cable.


2. FOR USING INTELLIGENT TESTER

CAUTION:
  1. Observe the following items for safety reasons:
  1. Read the tester's instructions prior to use.
  2. Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
  3. When driving the vehicle with tester connected, make sure 2 people are present. One person should drive the vehicle and the other should operate the tester.


3.FOR USING BATTERY DURING INSPECTION
  1. While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.