Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR (for 2WD)

FRONT SPEED SENSOR (for 2WD) > INSTALLATION

for Preparation Click here


HINT:
  1. The procedures listed below are for the LH side.
  2. Other than areas where instructions are provided, use the same procedures for the LH side and RH side.



1. INSTALL FRONT SPEED SENSOR LH


    C187999E01
  1. Install the 2 harness clamps with the 2 bolts.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    NOTICE:
    1. When installing the clamp, do not twist the wire harness.
    2. Make sure the clamp rotation stopper touches the installation position.

  1. Install the speed sensor with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
    2. While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
    3. After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
    4. When installing the sensor, do not twist the wire harness.



    C188000E01
  1. Install the harness clamp with the bolt.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    NOTICE:
    1. When installing the clamp, do not twist the wire harness.
    2. Make sure the clamp rotation stopper touches the installation position.



    C189975E01
  1. Install the harness clamp with the bolt.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    NOTICE:
    1. When installing the clamp, do not twist the wire harness.
    2. Make sure the clamp rotation stopper touches the installation position.

  1. Attach the clamp.



  1. Connect the connector.


    C188015E01

    NOTICE:
    1. Do not attach the connector to the radiator fan shroud before connecting the connector.
    2. Securely connect the connector.

  1. Attach the 2 clamps and the connector.

    NOTICE:
    When attaching the clamps, do not twist the wire harness.



2. INSTALL FRONT WHEEL

Torque:
for steel wheel:
152 N*m{ 1550 kgf*cm , 112 ft.*lbf }
for aluminum wheel:
121 N*m{ 1234 kgf*cm , 89 ft.*lbf }



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. CHECK SPEED SENSOR SIGNAL
  1. Check the speed sensor signal (Click here).