REAR SPEED SENSOR > INSTALLATION |
| 1. INSTALL SKID CONTROL SENSOR WIRE (TYPE A) |
![]() |
Install the speed sensor LH with the bolt.
![]() |
Install the speed sensor RH with the bolt.
Attach the 4 clamps.

Install the harness clamp with the bolt.
Connect the 2 connectors.
Attach the 2 clamps.

Connect the connector.
| 2. INSTALL REAR SPEED SENSOR (TYPE B) |
Install the speed sensor RH with the bolt.

Install the harness clamp with the bolt.
Attach the 3 clamps.
Install the speed sensor LH with the bolt.

Install the 2 harness clamps with the 2 bolts.
Attach the clamp.
Connect the sensor connector.
| 3. INSTALL REAR SPEED SENSOR (TYPE C) |
Install the speed sensor RH with the bolt.

Install the harness clamp with the bolt.
Attach the 2 clamps.
Attach the connector.
Connect the connector.
Install the speed sensor LH with the bolt.

Install the 2 harness clamps with the 2 bolts.
Attach the clamp.
| 4. INSTALL REAR WHEEL |
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. CHECK SPEED SENSOR SIGNAL |
w/ ABS:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Refer to BRAKE CONTROL / VEHICLE STABILITY CONTROL SYSTEM / TEST MODE PROCEDURE (200808-201008)).