Home › BRAKE › BRAKE CONTROL › DECELERATION SENSOR (for 4WD and Pre-Runner without VSC)

DECELERATION SENSOR (for 4WD and Pre-Runner without VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT SEAT ASSEMBLY RH
  1. for Separate Seat:
    Remove the front seat assembly RH (Click here).

  1. w/ Front Seat Side Airbag:
    Remove the front seat assembly RH (Click here).

  1. for Bench Seat:
    Remove the front seat assembly RH (Click here).



3. REMOVE FLOOR CARPET COVER


    C189946
  1. Detach the 4 claws and remove the floor carpet cover.



4. REMOVE SENSOR BRACKET
  1. Remove the 2 bolts and sensor bracket.



5. REMOVE DECELERATION SENSOR


    C189945E01
  1. Disconnect the deceleration sensor connector.

  1. Remove the deceleration sensor.