Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR (for LHD with VSC)

BRAKE ACTUATOR (for LHD with VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE BRAKE ACTUATOR ASSEMBLY


    C194677E01
  1. Use tags or make a note to identify the reconnection locations.



    C194678E01
  1. Release the latch of the actuator connector and disconnect the connector.

  1. Using a union nut wrench, disconnect the 6 brake lines from the actuator.



  1. Remove the 2 bolts, nut and actuator with bracket.

    NOTICE:
    C194679
    Be careful not to damage the brake tubes.



4. REMOVE NO. 3 BRAKE ACTUATOR BRACKET


    C194683E02
  1. Remove the bolt and No. 3 brake actuator bracket.