Home › BRAKE › BRAKE › BRAKE PEDAL (w/ VSC)

BRAKE PEDAL (w/ VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
w/ Airbag System:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE COMBINATION METER ASSEMBLY


B087852E01

NOTICE:
There are 2 types of combination meters. One type has a 40 pin connector and 16 pin connector. The other type only has a 40 pin connector.

  1. Remove the 3 screws <B>.

  1. Disconnect all connectors and remove the combination meter.



3. DISCONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Disconnect the stop light switch connector.



    C190666E01
  1. Remove the return spring.

  1. Remove the clip and clevis pin.

  1. Disconnect the push rod clevis from the brake pedal.



4. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY


C111299E01
  1. Remove the bolt from the support.



    C111300
  1. Remove the 4 nuts and support.