Home › TRANSMISSION ยท A343F AUTOMATIC TRANSMISSION › FLOOR SHIFT ASSEMBLY

FLOOR SHIFT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FLOOR SHIFT ASSEMBLY


G037855E01
  1. Install the floor shift with the 4 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



    G037854E01
  1. Connect the clamp and 2 connectors.

  1. Move the shift lever to L.

  1. Connect the transmission control cable.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


3. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



4. ADJUST SHIFT LEVER POSITION


G034515E01
  1. Remove the nut and disconnect the control cable.

  1. Remove the clip and disconnect the control cable from the control cable bracket.



    D028682E01
  1. Push the control shaft rearward as much as possible.

  1. Return the control shaft lever 2 notches to the N position.

  1. While holding the control shaft lever slightly toward the R position side, tighten the nut.

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }



5. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves rearward after shifting to R.
    If the results are not as specified, inspect the park/neutral position switch and check the shift lever.



6. INSTALL CONSOLE BOX ASSEMBLY


B090153E01
  1. Install the console box with the 2 clips, 4 screws <F> and 2 bolts <E>.



7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


B115418E02

NOTICE:
Be careful not to damage the instrument panel lower and console box with the claws of the console panel upper.

  1. Attach the 12 claws to install the console panel.



8. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B087844E02
  1. Attach the 4 claws to install the hole cover.



9. INSTALL TRANSFER SHIFT LEVER KNOB SUB-ASSEMBLY