Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for 2 Person Bench Seat Type)

FRONT SEAT INNER BELT ASSEMBLY (for 2 Person Bench Seat Type) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RHD and LHD vehicles.
  2. The procedures listed below are for the LHD vehicles.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT SEAT INNER WITH CENTER BELT ASSEMBLY RH


B125116E01
  1. Install the seat belt with its built-in bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



2. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)


B125217
  1. Install the buckle cover on the seat belt.



    B087821E01
  1. Install the seat belt with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not overlap the anchor part of the seat belt and protruding part of the seat adjuster.



    B087811E01
  1. Install the clamp as shown in the illustration.



3. INSTALL FRONT SEAT ASSEMBLY


B122862E01
  1. Place the seat in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. w/ Occupant detection sensor:
    Connect the connector under the seat.

  1. Install the seat with the 4 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.

  1. Pass the inner belts through the hole of the seat cushion.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION
  1. Perform Initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.