Home › ENGINE ยท 2TR-FE › STARTING › STARTER (for 1.6 kW Type)

STARTER (for 1.6 kW Type) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



3. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)


G034217E01
  1. Remove the 2 bolts and disconnect the release cylinder assembly.



4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)


C118024
  1. Remove the oil dipstick.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.



5. REMOVE STARTER ASSEMBLY


    G039103E03
  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.

  1. Remove the 2 bolts and starter.