Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for 2.2 kW Type Denso Made)

STARTER (for 2.2 kW Type Denso Made) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



3. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)


G034223E01
  1. Remove the 2 bolts and disconnect the release cylinder.



4. REMOVE STARTER ASSEMBLY
  1. for A340F A340E:
    Remove transmission oil filler tube sub-assembly.

    1. Remove the oil level dipstick.

    2. Remove the 2 bolts and transmission oil filler tube sub-assembly.

    3. Remove the O-ring from the transmission oil filler tube sub-assembly.



    A111843
  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A122908
  1. A/T:
    Remove the 2 nuts, bolt, and disconnect the ground cable.



    A122907
  1. M/T:
    Remove the nut, bolt, and disconnect the ground cable.

  1. Remove the starter.