Home › ENGINE ยท 2KD-FTV › STARTING › STARTER (for 2.0 kW Type)

STARTER (for 2.0 kW Type) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



3. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034223E01
  1. Remove the 2 bolts and disconnect the release cylinder.



4. REMOVE STARTER ASSEMBLY


    A195903
  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A195904
  1. Remove the nut, bolt, and disconnect the ground cable.

  1. Remove the starter.