Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for 2.7 kW Type)

STARTER (for 2.7 kW Type) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



3. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)


G034217E01
  1. Remove the 2 bolts and disconnect the release cylinder assembly.



4. REMOVE STARTER ASSEMBLY
  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A122803
  1. Remove the 2 nuts, bolt, and disconnect the ground cable.

  1. Install the starter.