Home › ENGINE ยท 1KD-FTV › STARTING › GLOW PLUG (w/ EGR Cooler)

GLOW PLUG (w/ EGR Cooler) > INSTALLATION

for Preparation Click here



1. INSTALL GLOW PLUG ASSEMBLY


A148178
  1. Using a 12 mm deep socket wrench, install the 4 glow plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



2. INSTALL NO. 1 INTAKE MANIFOLD INSULATOR


    A148177
  1. Install the manifold insulator to the cylinder head.



3. INSTALL NO. 1 GLOW PLUG CONNECTOR
  1. Install the glow plug connector by uniformly tightening the 4 nuts.

    Torque:
    2.2 N*m{ 22 kgf*cm , 19 in.*lbf }

  1. Install the 4 screw grommets.



    A149938E01
  1. Install the wire harness with the nut.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Install the No. 2 intake manifold stay with the bolt.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



4. INSTALL EGR COOLER
  1. Install the EGR cooler (Click here).



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.