INTAKE MANIFOLD (w/o EGR System) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Remove the 3 bolts, 2 nuts and cover.
| 3. REMOVE INTERCOOLER ASSEMBLY |
| 4. REMOVE DIESEL THROTTLE BODY ASSEMBLY |
![]() |
Disconnect the 2 connectors.
![]() |
Remove the 2 bolts, 2 nuts, throttle body and gasket.
| 5. REMOVE VACUUM SWITCHING VALVE BRACKET |
![]() |
Remove the 2 bolts and vacuum switching valve bracket.
| 6. REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET |
![]() |
Remove the 3 bolts and No. 2 intake air connector bracket.
| 7. REMOVE INTAKE AIR CONNECTOR |
Remove the 2 nuts, bolt, intake air connector and gasket.
| 8. REMOVE MANIFOLD STAY |
![]() |
Remove the 2 bolts and stay.
| 9. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE |
![]() |
Remove the engine oil level dipstick.
Remove the bolt and injection pipe clamp.
Remove the bolt and engine oil level dipstick guide.
Remove the O-ring from the engine oil level dipstick guide.
| 10. REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY |
![]() |
Remove the bolt and No. 2 injection pipe clamp.
Remove the 2 nuts and No. 3 injection pipe clamp.
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 1, No. 2 and No. 3 injection pipes.
| 11. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and disconnect the 2 injection pipe clamps.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.
| 12. REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY |
Disconnect the 3 fuel hoses.
![]() |
Remove the union bolt, 3 bolts, No. 2 nozzle leakage pipe and gasket.
| 13. REMOVE INTAKE MANIFOLD |
![]() |
Disconnect the vacuum hose.
Disconnect the VSV connector.
Remove the 2 nuts, 4 bolts, intake manifold and gasket.