GENERATOR (for BOSCH Made) > INSTALLATION |
| 1. INSTALL GENERATOR ASSEMBLY |
![]() |
Install the generator and with the 2 bolts.
Install the generator wire with the nut.
Connect the generator connector.
| 2. INSTALL FAN AND GENERATOR V BELT |
![]() |
Use the pulley set bolt of the tensioner to rotate the tensioner pulley clockwise, and then install the V belt.
![]() |
Make sure that the indicator mark of the tensioner is within range A, as shown in the illustration.
| 3. INSTALL AIR CLEANER ASSEMBLY |
Install the cleaner with the 2 bolts.
w/ Intake Air Temperature Sensor:
Connect the connector to the intake air temperature sensor.
w/ Mass Air Flow Meter:
Connect the connector to the mass air flow meter.
Tighten the hose clamp.
for Ventilation Hose Type:
Connect the ventilation hose.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |