Home › ENGINE ยท 2KD-FTV › EMISSION CONTROL › VACUUM REGULATING VALVE (w/ EGR System without EGR Cooler)

VACUUM REGULATING VALVE (w/ EGR System without EGR Cooler) > INSTALLATION

for Preparation Click here



1. INSTALL VACUUM SWITCHING VALVE BRACKET


    G035434E01
  1. Install the bracket (with E-VRV) with the 2 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the vacuum hose to the 2 locations.

  1. Connect the connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


3. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.