DTC P0335 Crankshaft Position Sensor "A" Circuit |
DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335 | When either condition below is met:
|
|
| P0339 | No crankshaft position sensor signal is input to ECM for 0.05 seconds or more, and conditions (a), (b) and (c) are met: (1 trip detection logic) (a) Engine speed is at 1,000 rpm or more (b) STA signal is OFF (c) 3 seconds or more have elapsed after STA signal is switched from ON to OFF |
|

| Item | Content |
| Terminal | (a) NE+ - NE- |
| Tester Range | 5 V/DIV., 20 msec./DIV. |
| Condition | Cranking or idling |

| 1.INSPECT CRANKSHAFT POSITION SENSOR |
![]() |
Disconnect the C4 crankshaft position sensor connector.
Measure the resistance of the crankshaft position sensor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Cold | 835 to 1400 Ω |
| 1 - 2 | Hot | 1060 to 1645 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C4 crankshaft position sensor connector.
Disconnect the E8 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| NE+ (C4-1) - NE+ (E8-27) | Below 1 Ω |
| NE- (C4-2) - NE- (E8-34) | Below 1 Ω |
| Tester Connection | Specified Condition |
| NE+ (C4-1) or NE+ (E8-27) - Body ground | 10 kΩ or higher |
| NE- (C4-2) or NE- (E8-34) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CRANKSHAFT POSITION SENSOR (SENSOR INSTALLATION) |
![]() |
Check the sensor installation.
|
| ||||
| OK | |
| 4.CHECK NO. 1 CRANKSHAFT POSITION SENSOR PLATE |
Check the teeth of the No. 1 crankshaft position sensor plate.
|
| ||||
| OK | ||
| ||