DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0340 |
|
|

| Item | Content |
| Terminal | (b) G+ - G- |
| Tester Range | 5 V/DIV., 20 msec./DIV. |
| Condition | Cranking or idling |
| 1.INSPECT CAMSHAFT POSITION SENSOR |
![]() |
Disconnect the C1 camshaft position sensor connector.
Measure the resistance of the camshaft position sensor.
| Tester Connection | Specified Condition |
| 1 - 2 | 835 to 1,400 Ω at cold |
| 1 - 2 | 1,060 to 1,645 Ω at hot |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C1 camshaft position sensor connector.
Disconnect the E7 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C1-1 - G+ (E7-23) | Below 1 Ω |
| C1-2 - G- (E7-31) | Below 1 Ω |
| Tester Connection | Specified Condition |
| C1-1 or G+ (E7-23) - Body ground | 10 kΩ or higher |
| C1-2 or G- (E7-31) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CAMSHAFT POSITION SENSOR (SENSOR INSTALLATION) |
![]() |
Check the sensor installation.
|
| ||||
| OK | |
| 4.CHECK PUMP DRIVE SHAFT PULLEY |
Check the condition of the pump drive shaft pulley.
|
| ||||
| OK | ||
| ||