DTC P0504 Brake Switch "A" / "B" Correlation |
| Signal | Brake Pedal Released | In Transition | Brake Pedal Depressed |
| STP | OFF | ON | ON |
| ST1- | ON | ON | OFF |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0504 | Conditions (a), (b) and (c) continue for 0.5 seconds or more: (1 trip detection logic) (a) Ignition switch is ON (b) Brake pedal is released (c) STP signal is OFF when ST1- signal is OFF |
|

| 1.CHECK OPERATION OF STOP LIGHT |
Check if the stop lights turn ON and OFF when the brake pedal is depressed and released.
|
| ||||
| OK | |
| 2.CHECK STP SIGNAL |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Stop Light Switch.
Read the value.
| Brake Pedal | Specified Condition |
| Depressed | STP signal ON |
| Released | STP signal OFF |
Measure the voltage of the ECM connectors.
| Tester Connection | Brake Pedal | Specified Condition |
| ST1- (E6-14) - E1 (E7-7) | Depressed | Below 1.5 V |
| ST1- (E6-14) - E1 (E7-7) | Released | 7.5 to 14 V |
|
| ||||
| NG | |
| 3.CHECK STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch.
Measure the resistance of the stop light switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin not pushed | Below 1 Ω |
| 3 - 4 | Pin not pushed | 10 kΩ or higher |
| 1 - 2 | Pin pushed | 10 kΩ or higher |
| 3 - 4 | Pin pushed | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - ECM) |
![]() |
Disconnect the S14 stop light switch connector.
Disconnect the E6 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| S14-1 - STP (E6-15) | Below 1 Ω |
| S14-4 - ST1- (E6-14) | Below 1 Ω |
| Tester Connection | Specified Condition |
| S14-1 or STP (E6-15) - Body ground | 10 kΩ or higher |
| S14-4 or ST1- (E6-14) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||