DTC P0405 Exhaust Gas Recirculation Sensor "A" Circuit Low |
DTC P0406 Exhaust Gas Recirculation Sensor "A" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0405 | EGR valve position sensor output voltage is less than 0.1 V for more than 5 seconds (1 trip detection logic) |
|
| P0406 | EGR valve position sensor output voltage is more than 4.9 V for more than 5 seconds (1 trip detection logic) |
|

| 1.CHECK TERMINAL VOLTAGE (EGR VALVE POSITION SENSOR CONNECTOR) |
![]() |
Disconnect the E2 EGR valve position sensor connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| VC (E2-1) - E2 (E2-2) | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 2.INSPECT EGR VALVE POSITION SENSOR |
![]() |
Disconnect the EGR valve position sensor connector.
Measure the resistance of the EGR valve position sensor.
| Tester Connection | EGR Valve Condition | Condition | Specified Condition |
| VC (1)- E2 (2) | - | 20°C (68°F) | 3.5 to 6.5 kΩ |
| EGLS (3) - E2 (2) | Fully opened | 20°C (68°F) | 3.9 kΩ |
| EGLS (3) - E2 (2) | Fully closed | 20°C (68°F) | 1.0 kΩ |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (EGR VALVE POSITION SENSOR - ECM) |
![]() |
Disconnect the E2 EGR valve position sensor connector.
Disconnect the E7 and E8 ECM connectors.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| VC (E2-1) - VC (E8-18) | Below 1 Ω |
| EGLS (E2-3) - EGLS (E7-33) | Below 1 Ω |
| E2 (E2-2) - E2 (E8-28) | Below 1 Ω |
| Tester Connection | Specified Condition |
| EGLS (E2-3) or EGLS (E7-33) - Body ground | 10 kΩ or higher |
| VC (E2-1) or VC (E8-18) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||