DTC P0180 Fuel Temperature Sensor "A" Circuit |
DTC P0182 Fuel Temperature Sensor "A" Circuit Low Input |
DTC P0183 Fuel Temperature Sensor "A" Circuit High Input |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0180 | Open or short in fuel temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| P0182 | Short in fuel temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| P0183 | Open in fuel temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 140°C (284°F) or more | Short circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (FUEL TEMPERATURE) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Fuel Temperature.
Read the value displayed on the intelligent tester.
| Temperature Displayed | Proceed to |
| -40°C (-40°F) | A |
| 140°C (284°F) or more | B |
| OK (Same as actual fuel temperature) | C |
|
| ||||
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (CHECK FOR OPEN IN WIRE HARNESS) |
![]() |
Disconnect the F11 fuel temperature sensor connector.
Connect terminals 1 and 2 of the fuel temperature sensor wire harness side connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Fuel Temperature.
Read the value.
|
| ||||
| NG | |
| 3.READ VALUE USING INTELLIGENT TESTER (CHECK FOR OPEN IN ECM) |
![]() |
Disconnect the F11 fuel temperature sensor connector.
Connect terminals THF and E2 of the E8 ECM connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Fuel Temperature.
Read the value displayed.
|
| ||||
| NG | ||
| ||
| 4.READ VALUE USING INTELLIGENT TESTER (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the F11 fuel temperature sensor connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine / Data List / Fuel Temperature.
Read the value.
|
| ||||
| NG | |
| 5.READ VALUE USING INTELLIGENT TESTER (CHECK FOR SHORT IN ECM) |
![]() |
Disconnect the F11 fuel temperature sensor connector.
Disconnect the E8 ECM connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Fuel Temperature.
Read the value.
|
| ||||
| NG | ||
| ||