Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FOG LIGHT ASSEMBLY LH


E170915
  1. Install the fog light with the 3 bolts.

  1. Connect the connector.



2. INSTALL FRONT BUMPER COVER


    B206030E01
  1. Put protective tape around the bumper cover.

  1. w/ Fog Light:
    Connect the 2 fog light connectors.

  1. w/ Headlight Cleaner System:
    Connect the headlight cleaner hose.

  1. Attach the 6 claws to install the bumper cover.



    B206029
  1. Install the 7 clips and 2 bolts.



3. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)


B206028
  1. Install the side cover with the 3 bolts and 2 clips.

    Torque:
    11.5 N*m{ 117 kgf*cm , 8 ft.*lbf }



4. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.



5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


B206027
  1. Install the splash shield with the 3 clips and 4 screws.



6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



7. INSTALL FRONT NO. 1 WHEEL OPENING EXTENSION PAD (for 4WD and Pre-Runner)


B206026
  1. Install the extension pad with the 2 screws.

    HINT:
    Use the same procedures to install the extension pad on the other side.



8. INSTALL RADIATOR GRILLE


B206025E01
  1. Put protective tape around the radiator grille.

  1. Attach the 6 claws to install the radiator grille.

  1. Install the 2 screws and 2 clips.



9. ADJUST FOG LIGHT AIMING
  1. Adjust the fog light aiming (Click here).