STEERING PAD SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 3 STEERING WHEEL COVER LOWER |
| 3. REMOVE NO. 2 STEERING WHEEL COVER LOWER |
| 4. REMOVE STEERING PAD ASSEMBLY |
![]() |
Straighten the front wheels.
Using a T30 "torx" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
Using a screwdriver, disconnect the airbag connector.
Disconnect the horn connector and remove the steering pad.
| 5. REMOVE STEERING PAD SWITCH ASSEMBLY |
![]() |
Disconnect all connectors.
Remove the screws.
Detach the 4 claws and remove the steering pad switch.