Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (w/ VSC)

BRAKE MASTER CYLINDER (w/ VSC) > REMOVAL

for Preparation Click here


NOTICE:
Release the vacuum from the booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from the brake booster assembly.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY



C197299E01

  1. for Manual Transmission:
    Disconnect the clutch reservoir tube from the master cylinder reservoir.

  1. Disconnect the brake fluid level warning switch connector.

  1. Using a union nut wrench, disconnect the 4 brake lines from the master cylinder and brake tube way.



    C197308E01
  1. Remove the 2 nuts and brake tube way.

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.



4. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Remove the master cylinder pin.

  1. Remove the reservoir and 2 grommets from the master cylinder.