Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Cold Area)

AIR CONDITIONING SYSTEM (for Cold Area) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.
  3. If the malfunction still exists even after checking and confirming that all the circuits are normal, replace the A/C amplifier.


A/C system 
Symptom
Suspected Area
See page
All functions of A/C system do not operate
1. A/C control assembly
Click here
2. A/C amplifier assembly
Click here
3. Wire harness
-
Air flow control: No blower operation
1. Blower resistor
Click here
2. Blower w/fan motor sub-assembly
Click here
3. A/C control assembly
Click here
4. Wire Harness
-
Air flow control: No blower control
1. Blower resistor
Click here
2. A/C control assembly
Click here
3. Wire Harness
-
Air flow control: Insufficient air comes out
1. Blower w/fan motor sub-assembly
Click here
2. Blower resistor
Click here
3. A/C control assembly
Click here
4. Wire Harness
-
Temperature control: No cool air comes out
1. Volume of refrigerant
Click here
2. Drive belt
Click here
3. Refrigerant pressure
Click here
4. Cooler compressor assembly
Click here
5. Magnet clutch relay
Click here
6. A/C pressure switch
Click here
7. Air mix control cable
-
8. A/C control assembly
Click here
9. Wire Harness
-
Temperature control: Output air is warmer or cooler than set temperature or response is slow
1. Air mix control cable
-
2. A/C control assembly
Click here
Temperature control: No temperature control
1. Air mix control cable
-
2. A/C control assembly
Click here
No air inlet control
1. Air inlet damper control cable
-
2. A/C control assembly
Click here
No air outlet control
1. Mode control cable
-
2. A/C control assembly
Click here
Engine idle-up does not occur, or is continuous
1. Cooler compressor assembly
Click here
2. A/C control assembly
Click here
3. A/C amplifier assembly
Click here
4. ECM
Click here

PTC heater 
Symptom
Suspected Area
See page
PCT heater does not operate, in these conditions: Engine coolant temp: 65 (149) or below, engine rpm is at idle rpm or more, temperature control knob: MAX HOT
1. PTC heater relay
Click here
2. Heater switch assembly
Click here
3. Air mix control cable
-
4. A/C control assembly
Click here
5. A/C unit assembly (Max. HOT switch)
Click here
6. A/C amplifier assembly
Click here
7. ECM
Click here
8. Wire Harness
-
9. Quick heater and accessory assembly
Click here

Hot gas heater 
Symptom
Suspected Area
See page
Hot gas heater does not operate, in these conditions: Engine coolant temp: 65 (149) or below, engine rpm is at idle rpm or more, temperature control knob: MAX HOT
1. Volume of refrigerant
Click here
2. Refrigerant pressure
Click here
3. Heater switch assembly
Click here
4. Hot gas heater magnet valve
Click here
5. Magnet clutch relay
Click here
6. A/C amplifier assembly
Click here

Viscous heater 
Symptom
Suspected Area
See page
Viscous heater does not operate, in these conditions: Engine coolant temp: 65(149) or below, engine rpm or more, temperature control knob: MAX HOT
1. Viscous w/ magnet clutch heater assembly
Click here
2. Heater switch assembly
Click here
3. Heater radiator unit sub-assembly
-
4. Heater amplifier assembly
Click here