Home › BRAKE › BRAKE CONTROL › SKID CONTROL BUZZER (w/ VSC)

SKID CONTROL BUZZER (w/ VSC) > INSTALLATION

for Preparation Click here




1. INSTALL SKID CONTROL BUZZER ASSEMBLY

HINT:
This illustration is for RHD vehicles. For LHD vehicles, the components' positions are on the opposite side.



    C189948
  1. Connect the buzzer connector.

    NOTICE:
    Securely connect the connector.

  1. Attach the clamp to install the buzzer.

    NOTICE:
    1. Securely insert the clamp into the bracket of the instrument panel reinforcement.
    2. If the buzzer is dropped, replace it.



2. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Install the upper instrument panel sub-assembly (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).