AUDIO AND VISUAL SYSTEM > Speed Signal Circuit |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMBINATION METER) |
![]() |
Disconnect the R12 receiver connector.
Disconnect the C8 meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R12-3 (SPD) - C8-6 | Always | Below 1 Ω |
| R12-3 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||