DTC P1264 VN Turbo Controller Malfunction |

| DTC No. | DTC Detection Condition | Trouble Area |
| P1264 | When communication error occurs between turbo motor and ECM (1 trip detection logic) |
|

| 1.INSPECT TURBO MOTOR DRIVER |
![]() |
Disconnect the T8 turbo motor driver connector.
Turn the ignition switch ON.
Measure the voltage of the turbo motor driver connector.
| Tester Connection | Specified Condition |
| +B (T8-3) - GND (T8-4) | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TURBO MOTOR DRIVER - ECM) |
![]() |
Disconnect the E8 ECM connector.
Disconnect the T8 turbo motor driver connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| VNTO (E8-10) - VNTO (T8-7) | Below 1 Ω |
| VNTI (E8-17) - VNTI (T8-2) | Below 1 Ω |
| Tester Connection | Specified Condition |
| VNTO (E8-10) or VNTO (T8-7) - Body ground | 10 kΩ or higher |
| VNTI (E8-17) or VNTI (T8-2) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT ECM (VNTO VOLTAGE) |
![]() |
While idling the engine, check the waveform of the ECM connectors using an oscilloscope.
| Tester Connection | Specified Condition |
| VNTO (E8-10) - E1 (E7-7) | Correct waveform is as shown |
|
| ||||
| OK | |
| 4.INSPECT TURBO MOTOR DRIVER (VNTI VOLTAGE) |
![]() |
While idling the engine, check the waveform of the ECM connectors using an oscilloscope.
| Tester Connection | Specified Condition |
| VNTI (E8-17) - E1 (E7-7) | Correct waveform is as shown |
|
| ||||
| OK | ||
| ||