CAN COMMUNICATION SYSTEM (w/ VSC) > Steering Angle Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Steering Angle Sensor Communication Stop Mode | When either condition below is met:
|
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (STEERING ANGLE SENSOR BRANCH WIRE) |
![]() |
Disconnect the S37 steering angle sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S37-4 (CANH) - S37-3 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (STEERING ANGLE SENSOR - BATTERY AND BODY GROUND) |
Reconnect the cable to the negative (-) battery terminal.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S37-2 (ESS) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S37-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| S37-6 (BAT) - Body ground | Always |
|
| ||||
| OK | ||
| ||