FRONT POWER SEAT MOTOR ASSEMBLY (for Slide) > INSTALLATION |
| 1. INSTALL FRONT POWER SEAT MOTOR ASSEMBLY (for Slide) |
![]() |
Install the slide cable.
![]() |
Install the front power seat motor assembly with slide cable to the slide screws.
Using a 4 mm socket hexagon wrench, install the 4 bolts.
Using a 5 mm socket hexagon wrench, install the 2 bolts.
![]() |
Install new 2 nuts.
Attach the claw to connect the connector to the seat frame.
![]() |
Connect the positive (+) battery terminal to terminal 1 of the power seat motor and the negative (-) battery terminal to terminal 2, and then slide the seat and align the matchmarks.
![]() |
Check that the matchmarks are aligned on both sides.
If the matchmarks are not aligned, check the installation condition of the power seat motor assembly, and remove and reinstall the power seat motor assembly if necessary.
Connect the connector.
![]() |
Install the seat cushion frame with the 4 bolts.
![]() |
Attach the 4 clamps indicated by the arrows in the illustration to install the seat cushion spring.
Attach the 2 wire harness clamps.
| 2. INSTALL SEAT CUSHION COVER WITH PAD |
Set the seat cushion cover with pad in place.
Attach the hooks to install the seat cushion cover with pad.

![]() |
Using hog ring pliers, attach the rubber bands of the seatback cover to the seat frame with new hog rings.
| 3. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH |
![]() |
Install the buckle cover on the seat belt.
![]() |
Attach the wire harness to the clamp.
Install the seat belt with the nut.
![]() |
Attach the clamp as shown in the illustration.
| 4. INSTALL FRONT SEAT CUSHION INNER SHIELD RH |
Pass the wire harness of the front seat inner belt assembly below the claw and into the front seat cushion inner shield.

![]() |
Attach the claw to temporarily install the cushion inner shield.
![]() |
Attach the guide and claw.
Install the screw to the cushion inner shield.
| 5. INSTALL FRONT POWER SEAT SWITCH |
![]() |
Connect the connector.
Install the switch with the 3 screws.
| 6. INSTALL FRONT SEAT CUSHION SHIELD RH |
![]() |
Attach the claw and guide to install the cushion shield.
Install the 3 screws.
![]() |
Install the 2 screws.
| 7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
![]() |
Attach the 4 claws to install the knob.
| 8. INSTALL RECLINING POWER SEAT SWITCH KNOB |
![]() |
Attach the 2 claws to install the knob.
| 9. INSTALL FRONT SEAT ASSEMBLY |
Install the front seat assembly (Click here).
| 10. INSPECT FRONT SEAT ASSEMBLY |
Check the power seat operation (Click here).