Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH


  1. Install the curtain shield airbag with the 9 bolts.


    B210352

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag when installing it.



    B211466
  1. Connect the connector as shown in the illustration.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL ROOF HEADLINING ASSEMBLY
  1. Install the roof headlining assembly (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).