STARTER (for 1.4 kW Type) > INSTALLATION |
| 1. INSTALL STARTER ASSEMBLY |
Install the starter with the 2 bolts.
Connect the starter wire to terminal 30 with the nut.
Install the terminal cap.
Connect the starter connector.
| 2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission) |
![]() |
Install the clutch release cylinder with the 2 bolts.
| 3. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission) |
![]() |
Coat a new O-ring with ATF, and install it to the oil filler tube.
Install the oil filler tube with the 2 bolts.
Install the oil dipstick.
| 4. INSTALL FRONT FENDER SEAL |
Install the seal with the 5 clips.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |