Home › ENGINE ยท 2TR-FE › STARTING › STARTER (for 1.4 kW Type)

STARTER (for 1.4 kW Type) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



3. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)


C118024
  1. Remove the oil dipstick.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.



4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)


G034217E01
  1. Remove the 2 bolts and disconnect the release cylinder assembly.



5. REMOVE STARTER ASSEMBLY
  1. Disconnect the starter connector.

  1. Remove the terminal cap.

  1. Remove the nut and disconnect the starter wire.

  1. Remove the 2 bolts and starter.