Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Signal Circuit

for Preparation Click here


DESCRIPTION

The headlight leveling ECU receives the low beam headlight on/off state information from the headlight dimmer switch to control the headlight beam level control system.

HINT:
Before performing troubleshooting of the automatic headlight beam level control system, check that the low beam headlights operate normally.


WIRING DIAGRAM


E228154E02


INSPECTION PROCEDURE

HINT:
After replacing the headlight leveling ECU, initialization of the ECU is necessary (Click here).

1.READ VALUE USING INTELLIGENT TESTER (HEADLIGHT)
  1. Using the intelligent tester, read the Data List (Click here).

    HL Auto Leveling 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Headlight Low Beam State
    Low beam headlight state / ON or OFF
    ON: Low beam headlights on
    OFF: Low beam headlights off
    -

    OK:
    The display is as specified in the normal condition column.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY AND BODY GROUND)
  1. Disconnect the C29 headlight dimmer switch connector.

  1. Disconnect the H17 headlight leveling ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    C29-20 (H) - H17-3 (B2)
    Always
    Below 1 Ω
    C29-12 (EL) - Body ground
    Always
    Below 1 Ω
    H17-3 (B2) - Body ground
    Always
    10 kΩ or higher
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    C29-11 (H) - H17-3 (B2)
    Always
    Below 1 Ω
    C29-19 (EL) - Body ground
    Always
    Below 1 Ω
    H17-3 (B2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


    E234736E01
  1. Remove the headlight dimmer switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Switch Condition
    Specified Condition
    20 (H) - 12 (EL)
    Headlight dimmer switch head
    Below 1 Ω
    Headlight dimmer switch off
    10 kΩ or higher
    for RHD 
    Tester Connection
    Switch Condition
    Specified Condition
    11 (H) - 19 (EL)
    Headlight dimmer switch head
    Below 1 Ω
    Headlight dimmer switch off
    10 kΩ or higher



NG
REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY (Click here)
OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)